seems like the exposure needs more tweaking.. personally, I go with thinner but more supports and wouldn't tilt a model like that at that sharp angle.. whatever works though, it's a matter of preference, really.
I use the B9 software to place my support. By manually placing them, you'll get all the right spots without any excess supports placed. Just like Dmitry said, it'll be a PITA to remove them without damaging the model.
@"Adriano Nocenzi" , it's a kinda "known bug". If you have small slits on the bottom or the top face, the liquid resin will remain there and cure. It's the nature of things called liquid tension. You can tilt the model but not less than 15 degrees to have smaller layer steps.
Комментарии
Adriano! The support pins are too big! You will have to be very accurate to remove them! What software have you used for that?
Look:
PS: I removed the UV filter from the projector.
Hopefully is improved