frame

Добро пожаловать к нам!

Скорее присоединяйтесь к участникам форума нажав на одну из кнопок ниже!

Войти Регистрация

Добро пожаловать к нам!

Похоже, вы здесь новенький. Чтобы принять участие, нажмите одну из кнопок ниже!

Поздравляем с днем рождения:

Help with Little RP printer

13»

Комментарии

  • seems like the exposure needs more tweaking.. personally, I go with thinner but more supports and wouldn't tilt a model like that at that sharp angle.. whatever works though, it's a matter of preference, really. 
  • Dmitry MedvedewDmitry Medvedew Дмитрий Медведев
    It's an alien creature!!!!

    Adriano! The support pins are too big! You will have to be very accurate to remove them! What software have you used for that?
  • Adriano NocenziAdriano Nocenzi Профиль не заполнен!
    Meshmixer
  • I use the B9 software to place my support. By manually placing them, you'll get all the right spots without any excess supports placed. Just like Dmitry said, it'll be a PITA to remove them without damaging the model. 
  • Adriano NocenziAdriano Nocenzi Профиль не заполнен!
    Hi all, I managed to get printed the calibration solid, but I can't get the upper part with details. What can I do?
  • Dmitry MedvedewDmitry Medvedew Дмитрий Медведев
    @"Adriano Nocenzi" , it's a kinda "known bug". If you have small slits on the bottom or the top face, the liquid resin will remain there and cure. It's the nature of things called liquid tension. You can tilt the model but not less than 15 degrees to have smaller layer steps.

    Look:


  • Adriano NocenziAdriano Nocenzi Профиль не заполнен!
    Thank you I will give a try tomorrow I will let you know thank you

    PS: I removed the UV filter from the projector.
    Hopefully is improved
  • robinhoodrobinhood Robin C
    отредактировано октября 2016
    That's a great illustration, Dmitry. I'd like to add that the letters depth should not exceed the width. 

    letters.PNG 18.1K
  • Adriano NocenziAdriano Nocenzi Профиль не заполнен!
    i tried no luck due the PDMS fail, i will most likely buy the flex vat part to sort this problem out so will be similar to the Solus 
Войдите или Зарегистрируйтесь чтобы комментировать.

j-DESIGN.PRO

Профессиональное обучение ювелиров, и всех, кто хочет ими стать.
J-DESIGN.PRO — Школа современного ювелирного дизайна
А. Полякова и Д. Медведева
Copyright © 2022 J-DESIGN.PRO

Контакты

info@j-design.pro
8 (800) 1000743
(звонок по России бесплатный)

Мы в социальных сетях