Help with Little RP printer

Комментарии

• robinhood Robin C

  сентября 2016

  seems like the exposure needs more tweaking.. personally, I go with thinner but more supports and wouldn't tilt a model like that at that sharp angle.. whatever works though, it's a matter of preference, really. 
• Dmitry Medvedew Дмитрий Медведев

  сентября 2016

  It's an alien creature!!!!
  
  Adriano! The support pins are too big! You will have to be very accurate to remove them! What software have you used for that?
• Adriano Nocenzi Профиль не заполнен!

  сентября 2016

  Meshmixer
• robinhood Robin C

  сентября 2016

  I use the B9 software to place my support. By manually placing them, you'll get all the right spots without any excess supports placed. Just like Dmitry said, it'll be a PITA to remove them without damaging the model. 
• Adriano Nocenzi Профиль не заполнен!

  октября 2016

  Hi all, I managed to get printed the calibration solid, but I can't get the upper part with details. What can I do?

  IMG_20161003_171351.jpg 2.5M
• Dmitry Medvedew Дмитрий Медведев

  октября 2016

  @"Adriano Nocenzi" , it's a kinda "known bug". If you have small slits on the bottom or the top face, the liquid resin will remain there and cure. It's the nature of things called liquid tension. You can tilt the model but not less than 15 degrees to have smaller layer steps.
  
  Look:
  
  
  

  QIP Shot - Screen 0781.png 86.8K
• Adriano Nocenzi Профиль не заполнен!

  октября 2016

  Thank you I will give a try tomorrow I will let you know thank you
  
  PS: I removed the UV filter from the projector.
  Hopefully is improved
• robinhood Robin C

  октября 2016 отредактировано октября 2016

  That's a great illustration, Dmitry. I'd like to add that the letters depth should not exceed the width. 
  
  

  letters.PNG 18.1K
• Adriano Nocenzi Профиль не заполнен!

  октября 2016

  i tried no luck due the PDMS fail, i will most likely buy the flex vat part to sort this problem out so will be similar to the Solus